Abstract: Present technology used for soft material cutting robot are laser, water-jet, ultrasonic, plasma and oxy-gas cutting. The scope for designing and fabrication of soft material cutting robots are increasing due to its cost effectiveness and quality of cutting.

en

Abstract: Electric discharge machining is an advanced machining technique. Spark is initiated between the tool and work piece interface which has a gap between them. Low material removal rate as well as low surface finish is a major concern of this process. Therefore,

en

Abstract: Active magnetic bearing (AMB) is a substitute of conventional bearing, which provides electromagnetic force to support the rotating part respecting the stator. The utilization of electromagnetic force makes this bearing “active”. The attraction force of an AM

en

Abstract: The use of synthetic fibers represents a huge negative impact on the environment. For this reason, the use of natural vegetable fibers as reinforcement of polymeric matrix composites has aroused great interest in the scientific community. In this study, the v

en

Abstract: Trends in crystalline silicon photovoltaic improvements demonstrate that some of the key factors that have contributed to reaching efficiency values up to 23 % are the introduction of the passivated emitter and rear cell structure with local rear contacts in

en

Abstract: Two forms of pollutants are usually discharged from scouring of wool fleece; namely the effluent liquid phase and the solid phase. These phases comprise a significant quantity of wool wax which would be a suitable candidate for valuable products and applicati

en

Abstract: The objective of this work was to produce activated carbon from the agricultural waste known as pineapple stubble and to test its effectiveness in the removal of methylene blue and surfactants. Activated carbon was prepared using ZnCl2 and H3PO4 as activating

en

Abstract: In this work, was studied and compared two bioremediation processes of sludge generated in service stations and fuel sales stations in the city of Tunja-Boyacá, Colombia, which are contaminated with total petroleum hydrocarbons (TPH). The mud samples were col

en

Abstract: The severe plastic deformation (SPD) techniques allow obtaining ultrafine-grained materials. Different SPD techniques permit processing sheet shape materials such as repetitive corrugation and straightening (RCS) and accumulative roll bonding (ARB). In this s

en